Licensed, insured, and on your roof within hours of the storm

Storm damage roof repair Cutler Bay FL done right the first time

When a squall line rolls off Biscayne Bay and rips shingles off your deck, you need storm damage roof repair Cutler Bay FL homeowners can count on. We handle emergency tarp-overs, wind uplift damage, hail bruising, and flashing failure for houses and commercial buildings across Miami-Dade County. One call and we are rolling - (855) 960-5906.

↗
Fast online booking

Request service today

Tell us what is happening. Our local team will confirm your visit shortly.

Call Now (855) 960-5906 → No spam. No obligation. Just practical help.
Local Roofing contractor team in Cutler Bay
Careful work. Honest options.
About this service

What storm damage roof repair Cutler Bay FL really involves

Storm damage roof repair Cutler Bay FL is the licensed trade of restoring a roof that has been compromised by wind, hail, rain intrusion, or flying debris - not just patching the shingle you can see from the driveway. A proper repair means pulling the damaged field, checking the underlayment and ice and water shield, replacing cracked pipe boots, resealing roof flashing, and verifying the decking underneath is still sound. We run a moisture meter and infrared camera across the ceiling line to catch water that traveled before it stains your drywall.

Cutler Bay sits in a wind-borne debris region, so every repair has to meet Florida Building Code and Miami-Dade County NOA standards or your insurance carrier can push back on the claim. After a named storm, we see the same three failures over and over: missing shingles on the windward slope, wind uplift damage at the rake edge, and hail damage that bruises the mat without cracking the surface. If you are searching for storm damage roof repair near me in Cutler Bay FL, that is exactly the work we do.

  • ✓ Emergency tarp same day
  • ✓ Insurance-ready documentation
  • ✓ Code-correct materials
  • ✓ Written scope before we start
What's included

What is included in storm damage roof repair

Every storm repair starts with a full inspection and a written scope. What follows is what we handle as part of the standard job, and what we quote separately when the damage goes deeper than the surface.

✓

Full roof inspection

We walk every slope, photograph the damage, and run a moisture meter along the interior ceiling line. This takes 45 to 60 minutes and tells us whether the problem is isolated or spread across the roof.

✓

Emergency tarp-over

If the roof is open to the weather, we dry it in with a 20x30 tarp and cap nails before we leave. That protects your interior while the insurance claim and repair scope move forward.

✓

Damaged shingle replacement

We remove the torn or missing shingles with a shingle remover, inspect the decking underneath, and install matching GAF Timberline or Owens Corning Duration shingles with a roofing nail gun set to the correct depth.

✓

Underlayment and flashing

New synthetic underlayment goes down across the repaired field, with ice and water shield at the eaves and new roof flashing at every penetration. This is the layer that actually keeps water out long term.

✓

Pipe boot and sealant work

Cracked pipe boots and dried sealant are two of the most common leak sources after a storm. We replace the boots and reseal every penetration with roofing sealant rated for South Florida heat.

✓

Insurance documentation

You get photos, measurements, and a written cause of loss you can send straight to your adjuster. We also talk to the carrier directly if the initial estimate comes in short of the actual scope.

How it works

How our storm roof repair in Cutler Bay works

01

Call and triage

You call (855) 960-5906 and describe what you see - missing shingles, a ceiling stain, granules in the gutter. We ask three questions about storm timing, roof age, and whether water is actively coming in. If it is an active leak, you go to the front of the line that day.

02

On-site inspection

A licensed inspector walks the roof with a roofing ladder and fall protection harness, photographs every slope, and runs a moisture meter along the interior ceiling. This takes 45 to 60 minutes on a typical 2,000 square foot home. You get the findings the same visit, not a week later.

03

Scope and tarp

If the roof is open to the weather, we tarp it before we leave the property. Then we write the repair scope: how many squares, which slopes, what underlayment and flashing get replaced. You see the numbers and the material brands before you approve anything.

04

Repair day

Crews arrive by 7:30 a.m. with the shingle remover, roofing hammer, and nail gun already loaded. We tear off the damaged field, inspect the decking, replace any rotted sheathing, then lay new underlayment, ice and water shield, and matching shingles. Most storm repairs finish in one day.

05

Final walk and warranty

We magnet-sweep the lawn and driveway for nails, then walk the roof with you from the ground using photos. You get the workmanship warranty paperwork and the manufacturer material warranty registration the same day. If anything moves in the first year, we come back at no charge.

Tools & methods

Tools and methods we use on every storm job

Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.

Roofing nail gun

Drives shingle nails to the correct depth and pattern without over-driving, which is one of the most common causes of shingle blow-off in high wind.

Shingle remover

Lifts damaged shingles and old underlayment without tearing up the decking underneath, so we can inspect the sheathing for rot before we rebuild.

Moisture meter

Reads water content in drywall, insulation, and decking so we can trace a leak to its actual source instead of guessing from the ceiling stain.

Infrared camera

Shows temperature differences behind the ceiling that reveal trapped moisture and hidden water paths the naked eye cannot see.

Fall protection harness

OSHA-compliant harness and anchor system used on every roof walk, because a steep pitch or wet shingle is not a place to take chances.

Chalk line

Snaps straight courses for shingle alignment and marks hail hit patterns for insurance documentation.

Tin snips

Cuts roof flashing and metal edge trim to fit around chimneys, vents, and valleys during the repair.

Real results

Before and after.

Wind-torn back slope in Cutler Ridge

Before

A 60 mph squall line peeled about 15 shingles off the back slope of a 1,800 square foot home. Water was dripping through the ceiling fan and the attic insulation was soaked across a 10 foot span.

After

We tarped the same afternoon, replaced the damaged field with matching GAF Timberline shingles, installed new ice and water shield at the eave, and replaced two cracked pipe boots. The interior dried out and the repair passed inspection.

Hail bruising on a Saga Bay roof

Before

A hailstorm left the roof looking intact from the ground, but the north slope was covered in granule loss and bruised mat. The homeowner's first claim was denied because there was no documentation of the hail hits.

After

We marked and photographed every hail hit, measured the density, and wrote a cause of loss report tied to the storm date. The carrier reopened the claim and approved a full slope replacement, which we completed in one day.

Flat roof ponding in Cutler Bay Town Center

Before

A commercial building had standing water across a 40 foot section of flat roof after a week of heavy rain. The membrane had a puncture near a rooftop unit and the seams were separating at the edge.

After

We cleared the clogged drains, patched the puncture, resealed the seams, and re-checked the drainage slope. Ponding stopped, the membrane held through the next storm, and the property claim was documented with photos and measurements.

Problems we solve

Storm problems we fix before they get worse

A storm-damaged roof rarely fails all at once. It fails in stages, and each stage costs more than the last. Here is what we see most often in Cutler Bay and how we stop it.

Ask a pro →
01

Missing shingles after high wind

We replace the missing field with matching shingles, check the surrounding tabs for uplift, and reseal the rake edge where wind gets under the roof. Most repairs finish in a single day.

↗
02

Ceiling stains from a hidden leak

We trace the water path with a moisture meter and infrared camera, find the real entry point at the flashing or pipe boot, and repair it. Then we confirm the attic is drying out before we close up.

↗
03

Hail bruising that looks fine from the ground

We mark hail hits with chalk, photograph them up close, and log the size and density against the storm date. That evidence is what gets hail damage roof repair Cutler Bay FL claims approved.

↗
04

Wind uplift at the roof edge

We reset the edge, install new starter course and ice and water shield, and fasten to Miami-Dade County NOA specifications. That edge detail is what keeps the rest of the roof locked down.

↗
Proof you can check

Licensed, insured, and documented

✓
Florida Roofing License (RR)Florida Department of Business and Professional Regulation
✓
GAF Master EliteGAF
✓
Owens Corning Preferred ContractorOwens Corning
✓
OSHA 30Occupational Safety and Health Administration
✓
Miami-Dade County NOA Product ApprovalMiami-Dade County Department of Regulatory and Economic Resources
Good questions

Frequently Asked Questions

(855) 960-5906 →

Most storm damage roof repair in Cutler Bay FL runs $450 to $2,800 in 2026, depending on how many squares are damaged and whether decking needs replacing. A small shingle and flashing repair is on the low end. A full slope rebuild with new underlayment and ice and water shield lands higher. Emergency tarp-overs start around $350 and are often reimbursed by your carrier.

Yes, in most cases. Florida policies cover sudden damage from wind, hail, and flying debris, and Miami-Dade carriers typically cover tarp-overs too. What they do not cover is wear and tear or a roof past its service life. We document the cause of loss with photos and measurements so your adjuster sees storm damage, not maintenance neglect.

Within 24 to 72 hours if water is getting in. A breached roof lets rain soak insulation and drywall, and mold can start in under 48 hours in South Florida humidity. Even if you see no interior leak, get it inspected within a week - wind uplift damage often opens a path that only shows up after the next hard rain.

The right company is the one that shows up with a license, insurance, and a written scope. Ask for the Florida roofing license, proof of general liability, and a workmanship warranty in writing. We have served Cutler Bay since 2021, hold GAF Master Elite credentials, and document every claim. Call (855) 960-5906 and judge us on the inspection.

Ready when you are

Get storm damage roof repair Cutler Bay FL started today

One call gets a licensed inspector on your roof and a tarp on the breach if water is coming in. We document everything for your insurance claim and give you a written scope before work begins. Call (855) 960-5906 now.

Call Now (855) 960-5906 →
Request an appointment

Contact our Cutler Bay roofers

Call (855) 960-5906 any time, day or night, and a real person picks up. For non-emergencies, we schedule free inspections Monday through Friday and can usually get to your property within 24 to 48 hours. If you have photos of the damage, text or email them over and we will take a look before we arrive.

Tap to call(855) 960-5906